Victron energy 48|350 User Manual

USER MANUAL GEBRUIKSAANWIJZING GEBRAUCHSANWEISUNG SKYLLA-TG 24/80 SKYLLA-TG 24/100 SKYLLA-TG 24/100 3-Phase TITAN 48/50

8 Manual Titan The Titan charger can remain connected to the battery continuously, without gas formation taking place, caused by overcharging.

Manual Titan 9 2.3 Protection The battery charger is safe to use due to its robust design and its internal electronic protection. This chapt

10 Manual Titan Temperature protection  The internal temperature of the charger is measured continuously. However, due to a high ambient temp

Manual Titan 11 3. DIRECTIONS FOR USE 3.1 Installation Find a dry and well-ventilated area to mount the Titan charger and battery. Keep the dista

12 Manual Titan - starter battery connection+ starter battery connectionGreen ledNegative battery connectionOutput fusesPositive battery conn

Manual Titan 13 Connecting the starter battery The starter battery has to be connected using wire with a core of at least 1.5 mm2.  Connect the

14 Manual Titan illustration 4b Connecting the 3phase mains  Check if the battery is already connected to the charger.  Remove the front o

Manual Titan 15 3.2 Operation Located on the front of the Titan charger are an on/off switch and three rows of leds, as shown in illustration 5.

16 Manual Titan After the batteries are charged the Titan charger does not have to be switched off and the batteries can stay connected to the

Manual Titan 17 4. OPTIONS The Titan charger is factory set to standard values. Some of these standard values can be changed by a qualified elect

18 Manual Titan 4.1 Permanent boost-charge In some cases, for example when the battery is almost empty, it is recommended to permanent boost-ch

Manual Titan 19 To change the boost-voltage:  Place DIP-switch 7 “Eq2” to the right and place DIP-switch 8 “R boost” to the left. The charger s

20 Manual Titan 4.5 Traction battery compensation If a Traction-battery is connected to the Titan charger the charge voltages have to be change

Manual Titan 21 4.8 Charging batteries with voltage sensing When high current runs trough a thin cable between the charger and the batter

22 Manual Titan When dip switch 2 “Watch” is positioned on the right, it is checked upon startup whether the battery voltage is sufficiently hi

Manual Titan 23 To connect the panel:  Disconnect the mains  Connect the on led to the “L_ON” connector.  Connect the ground of the panel to

24 Manual Titan 4.14 Connecting a voltmeter The remote-connector offers a possibility to connect a voltmeter. It is possible to connect a digi

Manual Titan 25 5. FAULT TRACING When a fault occurs in the battery charger, the following table can be used in order to find the fault. Before t

26 Manual Titan 6. TECHNICAL SPECIFICATIONS 6.1 General Switch on behaviour Charger can switch on under every load Efficiency 24/80

Manual Titan 27 Voltage compensation for diode-splitter, via DIP-switch + 0,6 V + 0,6 V + 0,6 V Model TG 24/80 TG 24/100 TG 48/

Manual Titan 1 SECTIONS Page English 3 Nederlands 31 Deutsch 59

28 Manual Titan connection wires up to 1,5mm² wires up to 1,5mm² Cooling Forced air cooling Forced air cooling Noise < 45dB(A) <

Manual Titan 29 © victron energy b.v.Skylla-TG 24/80, 24/100 and Titan 48/50 dimensionsdrawing no.: TI020000date: 220703revision.: 01220Ø 8Ø 625

30 Manual Titan © victron energy b.v. Skylla-TG 24/100 3-Phase dimensionsdrawing no.: TI030000 date: 130504 revision.: 00 220Ø 8Ø 6 2582002502

2 Manual Titan Copyrights  2004 Victron Energy B.V. All Rights Reserved This publication or parts thereof, may not be reproduced in any form,

Manual Titan 3 USER MANUAL SKYLLA-TG 24/80 SKYLLA-TG 24/100 SKYLLA-TG 24/100 3-Phase TITAN 48/50 Victron Ener

4 Manual Titan USER MANUAL TITAN GENERATION CHARGERS 1. INTRODUCTION 5 1.1 Victron Energy 5 1.2 The Titan Generation chargers 5 1.3 Wa

Manual Titan page 5 victron energie 1. INTRODUCTION 1.1 Victron Energy Victron Energy has established an international reputation as a leading de

6 Manual Titan The battery charger is NOT protected against reverse battery polarity.("+" connected to "

Manual Titan 7 2. DESCRIPTION 2.1 The Titan battery charger The Titan battery charger is a fully automatic charger for 24V or 48V batteries