Victron energy SKYLLA-TG 24/100 User Manual download pdf (Page 48)

PRECISION BATTERY MONITORING

www.victronenergy.com

Precision monitoring

The essential function of a battery monitor is to calculate ampere-hours consumed and the state of

charge of a battery. Ampere-hours consumed is calculated by integrating the current flowing in or out of

the battery. In case of a constant current, this integration is equivalent to current multiplied by time. A

discharge current of 10A during 2 hours, for example, amounts to 20Ah consumed. All our battery

monitors are based on a powerful microprocessor, programmed with the algorithms needed for

precision monitoring.

Standard information and alarms

- Battery voltage (V).

- Battery charge/discharge current (A).

- Ampere-hours consumed (Ah).

- State of charge (%).

- Time to go at the current rate of discharge.

- Visual and audible alarm: over- and under voltage, and/or battery discharged.

- Programmable alarm or generator start relay.

BMV 600S: low cost ultra high resolution monitor

- Highest resolution: 10mA (0,01A) with 500A shunt.

- Can be used with 50, 60 or 100mV shunts, current rating from 100A to 1000A

- Lowest current consumption: 4mA @12V and 3mA @ 24V.

- Easiest to wire: the BMV 600S comes with shunt, 10 meter RJ 12 UTP cable and 2 meter battery cable

with fuse; no other components needed.

- Easiest to install: separate front bezel for square or round appearance; ring for rear mounting and

screws for front mounting.

- Broadest voltage range: 9.5 – 95 VDC without prescaler needed.

- Communication port (Isolated RS232 interface is needed to connect to a computer)

BMV 602S: two batteries

In addition to all the features of the BMV600S, the BMV602S can measure the voltage of a second battery.

A version with a black front bezel (BMV 602S Black) is also available.

BMV 600HS: 70 to 350VDC voltage range

No prescaler needed. Note: suitable for systems with grounded minus only (battery monitor is not

isolated from shunt).

Optional Isolated RS232 communication interface and software

(for all BMV models) Displays all information on a computer and loads charge/discharge data in an Excel

file for graphical display.

VE.Net Battery Controller: any number of batteries

- One VE.Net panel or Blue Power panel will connect to any number of battery controllers.

- Comes with 500A/50mV shunt and can be programmed for 50, 60 or 100mV shunts, current rating from

100A to 10.000A.

- With use, abuse and data memory.

- Temperature sensor and connection kit included.

High voltage VE.Net Battery Controller: 70 to 350VDC

No prescaler needed. Note: RJ45 connectors are galvanically isolated from Controller and shunt.

Precision Battery Moni

toring

BMV 600S

Example of a battery charge

curve recorded with a BMV 602

and VEBat software

BMV 602S Black

VE.Net Battery Controller

BMV bezel square

BMV shunt 500A/50mV

With quick connect pcb

www.neoenerji.com

1 2 ... 43 44 45 46 47 48 49 50 51 52

Comments to this Manuals

No comments

Victron energy SKYLLA-TG 24/100 User Manual Page 48

Comments to this Manuals

Related products and manuals for Battery chargers Victron energy SKYLLA-TG 24/100